The use temperature is not suitable for gasketed plate heat exchangers within the range of 250 °C. The design temperature of the heat exchanger mainly depends on the temperature that its sealing gasket can withstand.

The gasketed plate heat exchanger manufacturer believes that the integrated heat exchange unit of the steam-water heat exchange unit can be used for both water-water exchange and steam-water exchange

First of all, the obvious point is that if it is not cleaned for a long time, the internal pipeline of the equipment will inevitably be blocked.

Gasketed plate heat exchangers are all detachable types, and the interior is composed of a variety of stamped corrugated sheets, and there will be a certain interval in the middle.

The plate type or corrugated type should be determined according to the actual needs of the heat exchange occasion. In the case of large flow and small allowable pressure drop, the plate type with low resistance should be selected, otherwise,

Plate heat exchanger gaskets can be divided into 3 forms according to the installation method on the heat exchange plate

With water as the experimental liquid, one-sided pressure experiments should be carried out on both sides respectively, and the experimental pressure should be 1.25 times the planned pressure.

The gasketed plate heat exchanger is usually composed of a water outlet chamber, a water inlet chamber, and the main sheet and the radiator chip. After the gasketed plate heat exchanger has been used for a long time,

1. Pay attention to the center of gravity of the equipment when hoisting.
2. When bonding the gasket to the gasket groove, it should be ensured that there are no debris such as sand, oil, iron filings and flux on the gasket and in the gasket groove of the plate, so as not to damage the seal and cause leakage.

The air heat exchanger is when the heat is transferred to the top of the equipment, it is to quickly discharge the transferred heat to the surrounding environment.