Ch
JINFAN
NEWS CENTER
Your location:
Homepage
/
/
/
Thermowave plate heat exchanger production process

Thermowave plate heat exchanger production process

(Summary description)The above is the production process of thermowave plate heat exchanger explained by thermowave plate heat exchanger manufacturers. I hope that after reading this article, everyone will have more understanding of thermowave plate heat exchanger.

Thermowave plate heat exchanger production process

(Summary description)The above is the production process of thermowave plate heat exchanger explained by thermowave plate heat exchanger manufacturers. I hope that after reading this article, everyone will have more understanding of thermowave plate heat exchanger.

Information

For most of us, thermowave plate heat exchanger may not be unfamiliar, but its production process may not be clear. Today we will take a look at the production process of thermowave plate heat exchanger, so that everyone can understand it.
1. Design and selection: Before production and processing, we need to select the thermowave plate heat exchanger, mainly to determine the plate model of the thermowave plate heat exchanger.

thermowave plate heat exchanger products
2. Plate processing: After selecting the plate model, the plate processing is required, mainly by pressing the corresponding corrugations on the plate through the punching process. It should be noted that the plate pressing needs to be formed once to ensure the quality of the plate.
3. Assemble the thermowave plate heat exchanger: wipe the parts clean, before bonding the sealing gasket to the groove, wipe off the residual glue in the groove, apply the synthetic resin adhesive to the plate, and then press into the sealing gasket. The plates should be alternately rotated 180° for stacking, and no wrong installation is allowed. The clamping bolts should be tightened until the length of the plate bundle reaches the calculated value.
4. Stamping and shaping: press the installed plates to make full contact between the plates and the joining materials between the layers.
5. Welding process: According to the different requirements of customers, different types of interfaces and accessories are welded to the thermowave plate heat exchanger.
6. Leak detection and pressure test: The thermowave plate heat exchanger is pumped to a vacuum state for leak detection. Thermowave plate heat exchangers that have undergone leak detection need to undergo a pressure test higher than the customer's requirements. The test method is generally nitrogen pressure, and then put in a water tank to maintain the pressure to check for leaks.
7. Drying and packaging: qualified products after inspection are dried to remove moisture and impurities, and then packaged for delivery.

The above is the production process of thermowave plate heat exchanger explained by thermowave plate heat exchanger manufacturers. I hope that after reading this article, everyone will have more understanding of thermowave plate heat exchanger.

Keyword:

Scan the QR code to read on your phone

Username used for comment:
客户留言
Description:
验证码

Home

 

 

About Us


News


> Products


Equipment


Service

 

Contact Us

No. 8 Jianshe Road, Balitai Industrial Park, Jinnan District, Tianjin

facebook

Time of issue:2020-02-11 00:00:00

tu tu  tu

WeChat Public

 天津市金帆模具有限公司

Copyright: Tianjin Jinfan Mould Co., Ltd.  津ICP备20001482号-1   Powered by www.300.cn

天津市金帆模具有限公司